EPS Stromversorgung 06230204, Руководство по эксплуатации, Страница: 55 / 66

Page 55
EPS Stromversorgung GmbH
Alter Postweg 101 • 86159 Augsburg
Germany
Fon: +49 821 / 570451-0
Fax: +49 821 / 570451-25
www.eps-germany.de
info@eps-germany.de
PS 9000 2U Series
► How to configure the device alarms OVP, OCP and OPP
1.
Switch off the DC output and push button to call the setup menu.
2.
In the menu navigate to “ Settings” and push . Then in the submenu navigate to “ Protection Settings ”
and push again.
3.
Set the limits for the equipment alarm relevant to your application if the default value of 110% of nominal is
unsuitable.
4.
Accept the settings with or discard them with .
Those thresholds are reset to defaults when using the function “ Reset Device ” in setup menu.
► How to configure the alarm sound
1.
Switch off the DC output and push button to call the setup menu.
2.
In the menu navigate to “ HMI Setup” and push . Then in the submenu navigate to “ Alarm Sound ”
and push again.
3.
In the following screen set parameter “ Alarm Sound” to either OFF or ON .
4.
Accept the settings with or discard them with .
3.7 Control panel (HMI) lock
In order to avoid the accidental alteration of a value during manual operation the rotary knobs or the key strip of
the control panel (HMI) can be locked so that no alteration will be accepted without prior unlocking.
► How to lock the HMI
1.
Switch off the DC output and push button to call the setup menu.
2.
In the menu navigate to “ HMI Setup” and push . Then in the submenu navigate to “ HMI Lock ” and
push again.
3.
Make your selection for parameter “
HMI Lock
”. With selection “
Lock all
” everything on the HMI is locked
and you can’t even switch on the DC output. In order to be able to do at least that, use “ ON/OFF possible ”.
4.
The lock is activated as soon as you confirm your selection with . The device will automatically exit the
menu and jump back to normal display with status “
Locked
” now being indicated.
If an attempt is made to alter something whilst the HMI is locked, a requester appears in the display asking if the
lock should be disabled.
► How to unlock the HMI
1.
Rotate any knob or push any button except ON/OFF.
2.
This request pop-up will appear: .
3.
Unlock the HMI by pushing within 5 seconds, otherwise the pop-up will disappear and the HMI re-
mains locked.