Spftware Installation
EP-USB66
Page 15
b. Make sure that a power cable is properly attached to each drive attached to the
HPT366 host adapter.
If the driver has been started and you still cannot access the hard disk drive
attached to the HPT366 host adapter, the hard disk drive might have not been
partitioned and formatted yet. You may need to partition and format it.
5. Removing a Host Adapter
Removing a host adapter can be as simple as physically removing it from the slot
when your computer is shut down. Windows NT boots and functions properly in
this configuration, but a warning message is generated every time you boot
Windows NT. To eliminate the warning message, you must update the Windows
NT software configuration, as described in the following steps:
a. Open My Computer.
b. Open Control Panel.
c. Double click SCSI Adapters.
d. Click Drivers.
e. Select HPT366 Ultra DMA Controller, then click Remove.
Systems Without Windows NT 4.0 Already Installed
1. Start Windows NT setup from CD-ROM or NT install disks.
2. When Windows NT setup asks for addtional host adapters, please select SCSI
type host adapter.
3. Then Windows NT will ask you to install device driver for that SCSI type
host adapter (HPT366).
4. Insert the driver disk into the floppy drive and allow Windows NT to read the
driver.
5. After installing HPT366 files from the floppy, users will see "HPT366 Ultra
DMA host adapter."
6. Continue installation of Windows NT.
