pg. 2
ECS-650-PND Owner’s Manual
SPEAKER INSTALLATION
General Guidelines
• Keep speakers about 2 feet away from corners and other surfaces that might interfere with or reflect sound, such as
tall furniture.
• For rooms less than 300 square feet, two speakers should suffice. The further apart they are, the better the sound will
be. However, keep the distance at a maximum of 8-10 feet to avoid a “hole” in the middle.
• For rooms larger than 300 square feet, use 3 or more speakers. Stagger them across the space for ideal sound
dispersion
1. Unpack speaker and
hanging hardware. Use the
stow away handle for easy
handling and transporting
of the speaker.
4. Thread hanging cable
through the clamp as shown.
7. Attach the cable by securing
it to the 3-hole hanger as
shown. Use included safety
cable when required.
3. Connect signal wire to either
of the (+) and (-) slots on the
screw-terminal connector.
Ensure correct polarity and
tighten unused terminal
screws. Empty slots can be
used as speaker loop-outs.
Refer to Speaker Wiring section
on Pg. 1 for more information.
WARNING: Do not use the
stow away handle for hanging
the speaker. Use the 3-hole
configured hanger to suspend
the speaker.
WARNING: Do not set the
speaker for 8 ohm operation if
using a 70V or 100V amplifier.
This could cause permanent
damage to the speaker or
amplifier.
6. Thread cable end(s)
through clamp as shown.
Adjust speaker height with
the clamp.
9. Secure cables and
speaker wire.
2. Select the desired tap
setting.
5. Attach the hanging cable
by securing it to structure
as shown.
8. Plug screw-terminal
connector into jack on rear
of speaker.
