© 2014 Episode
®
pg. 1
ECS-650-PND Owner’s Manual
WELCOME TO EPISODE
®
Thank you for purchasing a great product from Episode
®
,
one of the best sounding speaker lines available today.
We appreciate your purchase and are committed to
providing the highest quality products possible.
The ECS-650-PND series speaker line is a superb
choice for 70V/100V music distributed-line systems, and
can even be set to bypass the transformer if you need an
8 ohm speaker in a pinch.
KIT-ECS-650-PND4-BLK | KIT-ECS-650-PND4-WHT | KIT-ECS-650-PND6-BLK | KIT-ECS-650-PND6-WHT
OWNER’S MANUAL
Episode
®
Commercial 650 Series Pendant Speaker
• (1) ECS-650-PND4 or ECS-650-PND6 Loudspeaker
• (2) Hanging hardware kits
PACKAGE CONTENTS
• #2 Phillips Screwdriver
• Small Flathead Screwdriver
• Wire Strippers
TOOLS REQUIRED
The installation methods should be in accordance with the applicable section of the National Electrical Code, ANSI/
NFPA 70, and/or the National Fire Alarm Code, ANSI/NFPA 72, as applicable. The wiring method and compartment
should not interfere with the operation of the speaker.
IMPORTANT INSTRUCTIONS AND CONSIDERATIONS FOR INSTALLATION
Clamp
Speaker Wire
Jack
Pendant Speaker
Tap Switch
Jack
Hanger
Tap Location
Screw-terminal connector
Cable
Cable
with clip
Stow Away
Handle
Secure Anchor
Point
SPEAKER WIRING
Overview
In a 70V or 100V system, a speaker wire is run from the amplifier location to the first speaker location. A “loop out” is run
from the first speaker to the second speaker, the second speaker to the third speaker, etc. In 8 ohm (Low Impedance)
applications, a separate speaker wire must be run from the amplifier to each speaker location.
Recommended Wiring
• 70V/100V applications: 18 AWG, stranded, 2 conductor cable.
• 8 ohm (Low Impedance) applications: 16 or 14 AWG, stranded, 2 conductor cable.
