Episode ES-LS-SAT-4, Руководство пользователя

Страница: 5 / 8

pg.5
www.snapav.com Support: 866.838.5052
ES-LS-SAT Installation Manual
5.4 Speaker Connections
Proper connections are important to the performance of any loudspeaker within an audio system. Performing the
following steps will ensure proper connections for optimum performance and reliability.
Warning! Leave the amplifier unpowered and disconnected from the speaker line until all other connections have
been made.
5.5 Transformer Tap Settings
ES-LS-SAT loudspeakers have an adjustable tap setting switch located under the removable rear cover. To
adjust the setting, use a flat or Phillips screwdriver to rotate the tap setting dial on the rear of the speaker to the
desired mark. When the adjustments are complete and fully tested, install the rear cover of the speaker and
hand-tighten it until it is secure.
ES-LS-SAT speakers used in 70/100 volt systems can be set to different wattages for more or less volume at one
particular speaker. This makes it much easier to fine tune a system for even listening volume.
1. Install the loudspeaker mount to the
loudspeaker.
2. Route the loudspeaker cable into the
loudspeaker mount. Take care not to damage the wire insulation.
3. Strip the outer jacket of the cable to separate it from the insulated wires inside by at least 2 inches. If a
location has a wire loop instead of an end, cut the wire to make a splice point.
4. Strip the insulation on each conductor back approximately ½ inch.
5. Twist the wire/s from the run together with the loudspeaker wire in a clockwise direction; all – (common)
wires together and all + (positive) wires together.
6. Insert each set of wires into a waterproof wire nut and twist the nut clockwise until it is firmly seated. Make
sure the wire nut completely covers the bare copper. A small amount of silicone may press out of the wire
nut as the wires are inserted; this is normal and should be left on the wire for the most reliable connection.
7. Close or secure the connections and the loudspeaker mount per the mount instructions or local building
codes.
8. Set the transformer switch to the correct tap setting per the Transformer Tap Settings section before
connecting an amplifier to the system.
Warning! The silicone-filled weatherized wire nuts
included with this kit are specially designed to be used
for direct burial installations. An equivalent connector
must be used for any wiring in the system that could be
exposed to water or weather.
Damage to loudspeakers or connected equipment due
to inadequate installation will not be covered under
warranty.
From Amp or
Previous Speaker
To Next Speaker
(If Not Last Speaker)
Warning! The ES-LS-SAT loudspeaker tap must be set accordingly for
the type of amplifier in use (8Ω or 70/100volt). Setting the transformer
incorrectly for the amplifier used could damage the speakers or amplifier
and is not covered under warranty
8
70V
100V
Ω
7.5W
15W
15W
7.5W
3.75W
30W
30W
8 Ω