page | 2
Support 866.838.5052
INTRODUCTION
Thank you for purchasing Episode® speakers. To complete installation,
follow these instructions. Visit our website for design recommendations
and speaker calculators.
PACKAGE CONTENTS
• ES-AW-360-6-BRN
• Weatherproof Wire Nuts
TOOLS REQUIRED
• Coin to adjust tap switch
• Wire Stripper
SETUP
Determining Speaker Locations
• Plan locations with no more than 25’-30’ spacing between speakers.
Using more speakers in an area allows for more even sound coverage.
The final volume of the speakers can be set using the 70 volt systems
wattage tap setting. See the
FINE TUNE
section on page 4.
• If using a stereo sound system, place left and right speakers evenly to
avoid uneven sound.
Mounting Considerations
The speakers will not be damaged by normal rainfall, however sprinkler
systems may cause damage to the internal audio components. Avoid
placing the speakers within direct sprinkler stream areas.
CONNECT
!
CAUTION:
Do not supply power to the amplifier or connect the
speaker line until all other connections have been made.
NOTE:
The silicone-filled weatherized wire nuts included with this kit are
specially designed to be used for direct burial installations. An equivalent
connector must be used for any wiring in the system that could be exposed
to water or weather.
1. Attach the mount to the speaker.
2. Carefully route the speaker cable into the speaker mount, to avoid
damage to the wire insulation.
