EA-MINI-2D-35 EA-MINI-3D-35
IR Command Learning Procedure
www.SnapAV.com Support: 866.838.5052
© 2013 Episode
®
Introduction
EPISODE
®
EA-MINI amplifiers feature optional IR Learning Mode, which allows control of the amplifier using
the remote for a display or any other remote on a job. After completing the learning procedure, the same
buttons for power toggle, volume up, volume down, mute toggle, and input toggle on the selected remote
will also control these settings for the amplifier.
Procedure Overview
To complete IR Learning, an IR Receiver must be connected. Set up the amplifier as shown below and select
the remote that will be used for control. Then, go to the second page of the guide (flip over) and complete
the learning procedure. Note the DIP switch locations and positions before attempting the procedure.
Tips & Troubleshooting
•
Make sure the source remote contains a fresh battery.
•
Use only
factory
remotes for IR learning. A universal or programmable remote may add data to the
command that makes it unreadable by the amplifier for Learning mode. They may be used for operation
after setup.
•
If commands aren’t being received correctly, try relocating the IR receiver. Interference from CFL lighting,
plasma or LED television screens, or IR from other equipment may cause issues.
•
IR learning may be stopped after any command. Wait 20 seconds for Learning mode to time out. The
LED will change from flashing BLUE to solid PINK for 2 seconds, and then return to solid BLUE to indicate
RUN mode. You may unplug the IR receiver during the time out to avoid interference.
Do not
return the
dip switch to Run Mode before time out or the memory will be cleared.
•
The same button on the remote
cannot
control more than one amplifier command at a time.
•
If a particular command does not have a corresponding button on the remote, any other unused button
may be substituted. For example, source remotes may not have an “input toggle” button or function.
Instead, program an unused button for input switching and make note of it for the end user.
•
IR learning mode will deactivate after 20 seconds of inactivity (no commands received). If IR learning
mode deactivates before learning is complete, reset the amplifier (set DIP switch 2 UP to the RUN and
press master reset while amplifier is ON) and then start the IR Learning procedure again. Any commands
learned before will be erased.
READ ALL OF THIS SIDE FIRST - Page 1 of 2
Page 1/2
R+ R- L+ L-
DIGITAL IN
SUB OUT
ANALOG IN
RIGHT
1 2 3 4 5
IR IN
IR OUT
+5V GND
RESET
SPEAKER OUTPUTS
STATUS
1
2
LEFT
SWITCHES
100-240V~50/60Hz 1.6A
UP
1
2
3
4
5
CONTROL
DOWN
IR
RECEIVER
RUN
LEARN
MONO
STEREO
FULL
HP 60Hz
IN 1
IN 2
SWITCH POSITION
1 2 3 4 5
SWITCHES
1 2 3 4 5
SWITCHES
Status LED provides IR Learning Feedback
DIP Switch 2 DOWN for IR LEARNING MODE
DIP SWITCH 1 DOWN FOR IR RECEIVER POWER
IR RECEIVER
(Not Included)
Plugged into
IR IN Port
