PRO 32 & 48 X-AXIS BELT
3
2. Locate the x-axis belt clamps, just to the
left and right side of the lens carriage
assembly.
3. Remove the four (4) 3/32” inner x-axis belt
clamp mounting screws:
Connecting the Belts
1. Thoroughly clean the outer (smooth)
side of the belt that is currently installed
in the engraver.
2. Pull the right side of the belt away from
the lens assembly and place it next to
the new belt end-to-end.
Before securing the old and new belts to-
gether, ensure that the orientation of the
teeth match. The teeth of the belt just face
towards the rear of the engraver, while the
smooth side should face the front of the
engraver.
3. Using a heavy-duty tape, such as
Duct Tape, join the old and new belts
together by placing a strip of tape on
the outer (smooth) sides:
4. Place an additional piece of tape
around the connection point of the new
and old belts:
5. Once the new and old belts have been
joined together, attach the right side
belt clamp to the untaped side of the
new belt. This will prevent the new belt
from being pulled into the reducer
housing.
