Epifani American Tweed 4x10, Руководство пользователя

Страница: 4 / 8

1. Tweeter Level
Attenuates the output level of the tweeter. Choose
Low, Medium, High, or Off. Select high frequencies are
sent to the tweeter via the integrated crossover.
2. Speaker Input/Output
2. Input/Output
Combination Neutrik Speakon™ and 1/4-inch TS
connector, wired in parallel so you can plug in to either
connector. We recommend Speakon-to-Speakon
cables.
The input/output connections on the back of your
cabinet are wired in parallel. If you daisy chain two 8
Ohm cabinets, you will have a total impedance of 4
Ohms.
If your amp’s minimum load is 4 Ohms, it means that
you can use one 8 Ohm, or two 8 Ohm cabinets, or a
single 4 Ohm cabinet.
American Tweed cabinets are equipped with combo
Neutrik Speakon connectors. This means that you can
use a Speakon speaker cable or a 1/4-inch speaker
cable to connect your amp and other cabinets.
In the center of the Speakon connector is a 1/4-inch
jack that will accept a standard 1/4-inch speaker cable.
For higher power handling and a more secure
connection, use Speakon-to-Speakon cables with
a speaker wire of at least 16-guage. A lower gauge
number means thicker cabling. So, a 14-guage cable
is thicker in diameter and thus better than a 16-guage
cable. Thicker cabling means better low frequency
transmission to the cabinet(s).
The pin connection inside the Speakon connector
should be +1 and -1. Be sure to specify this
configuration when buying your speaker cables.
Although this is the most common style, it is not
the only one available. The correct speaker cable is
available from Epifani. To purchase, visit
www.epifani.com
Control Panel The Tao of Impedance