12
EATON
MN507001EN
Installation instructions rev 170117
Installation Instructions - All Field LED Luminaire
3. Slightly loosen the fixture aiming screws just enough to allow the fixture to rotate and tilt.
4. Turn on the laser and aim the fixture by targeting the green laser dot at the aiming point. If aiming tube is used, look
through tube and adjust fixture until aiming point is centered in view through tube. Refer to photometrics or project
installation drawings for aiming point coordinates.
otee:
N
After targeting the aiming point with the laser, turn off the laser to conserve battery life.
Hardware
Torque Value
Side Set screw
35-75 in-lbs (4 to 8 N-m)
Side Hex screw
25-35 ft-lbs (34 to 47 N-m)
Mounting bolt/nut
35-45 ft-lbs (47 to 61 N-m)
1. Insert the laser or tube into the aiming mount and tighten the holding screw.
2. Insert the aiming mount onto the fixture aiming pin until it is fully seated. Aiming mount must be tight against the fixture
because any movement or wiggle in the mount will cause aiming to be inaccurate.
Figure 10. Aiming
Hex
Screw
Mounting Hardware
Aiming Laser or Tubing
Set
Screw
