EPAK TVRO Systems
7. The search mode stops after a satellite is found. The dis-
play shows
Sat
OK?
(flashing). Check the quality of the TV
picture! In case there is no picture or the wrong TV program,
proceed with search mode by pressing
q
repeatedly until the
correct TV signal is found. Press
a
to confirm.
8. The display shows
Save as?
just for a few seconds.
A list of the different storage positions is shown. Use the
q
key to toggle between
Sat
1
and
Sat
4
, confirm with
a
.
Hint! Only free storage positions are shown. Every receiver
supporting the DiSEqC
TM
-function, allocates the satellite po-
sitions to one of the DiSEqC
TM
-positions 1-4. Therefore, make
sure that all satellites in the DiSEqC
TM
- menu of the receiver
and of the antenna unit are stored under the same num-
ber! This allows the use of Auto Sat function (Only for Single
and Twin antennas! - see point 5.4.1 in the antenna manual).
Example: Satellite Astra is stored under DiSEqC
TM
-position 2
in the receiver, meaning that this satellite has to be stored in
the antenna unit under Sat 2! Receivers which do not sup-
port the DiSEqC
TM
-function will allow any order of numbers.
Press
a
.
9. The display interchanges between a flashing
Sat
[1-4]
and
save?
. Confirm with
a
.
10. If you choose to Confirm in point 9, the display shows
saving..
(flashing) for 10 to 20 seconds. The data of the
satellite is now automatically memorized and stored. The dis-
play shows
checking
. While the data is being stored, the
ship may not strongly move. Also, a permanent clear view to
the satellite must be guaranteed and the antenna unit may
not be turned off!
11. When the data is memorized, the display shows
complete
for a brief moment and then the system au-
tomatically jumps to the TV mode of the just stored satel-
lite (the display shows
Sat
[1-4]
). The ship can now
be moved and the reception tested. In case a failure occurs
and the data is not memorized correctly, the display shows
Err Save
and the search has to be done again.
For each new satellite the search mode must be repeated! You
can store up to four satellites on each antenna.
5. Deleting stored satellites
To delete stored satellite positions, the following steps must
be completed:
1. Press
q
repeatedly until
Del
Sat
appears. Press
a
to
select.
Hint! Del Sat can only appear if satellites are stored in the sys-
tem.
2. The display shows
Sat
[1-4]
, which is the first storage
position that can be deleted. Choose the satellite you want to
delete using
q
and confirm with
a
.
3. The display now interchanges between
Sat
[1-4]
and
Delete
. To confirm press
a
, to cancel press
q
.
4. If you choose Confirm (
a
) the display shows
complete
for a brief moment. If you choose Cancel (
q
),
the display shows
cancel
. If there are further satellites
available the display will return to
Del
Sat
, otherwise it
shows
Tracking
.
For each satellite you wish to delete, press
a
and repeat from
step 3!
Complete manual available for download on www.epak.de
(Download Area).
QUICKSTART
01.03.18
ID: 0118
