EPAK DS13 PRO, Инструкция по установке и эксплуатации

Страница: 17 / 33

E Status LEDs Shows a quick view of the status of the Receive Signal, Internet
connectivity and System errors status.
RX – (green – Antenna locked, blue – unlocked, off / white – No
connection to antenna)
NET – (green – Internet Access to ACU via LTE or any other external
gateway, blue – no access to internet)
Status – (red – Errors in ACU, off / white – no ACU errors)
F Display Displays the current status of the ACU and antenna.
G Input Buttons The input keys lets you navigate the menu and access quick settings.
H Sim Slots The user can insert standard SIM cards in SIM1 or SIM2
Back-Panel Schematic:
A: IDB1 Connector G: NMEA Connector M: Unused port for TVRO
B: IDB2 Connector H: NMEA Protocol Select N: Unused port for TVRO
C: Serial Connector RS232 I: GPIO Connector (opt.) O: Unused port for TVRO
D: WAN Connector J: LTE Antenna connector P: Fan Outlet
E: LAN2 Connector K: USB Port Q: Slave Mains Power Connector
F: Unused port for TVRO L: Antenna RX R: Mains Power Input and Switch
A
+
B IDB Connector (RJ45) Use these ports to connect several EPAK devices together (e.g.
DivKit, second ACU, heating controller).
Use only if you are instructed to do so by a technician.
C Serial Connector RS232 (RJ45) Connect this port to a RS232 device which should be controlled by
the ACU.
Use this port only if you are instructed to do so by a technician.
D WAN Connector (RJ45) Connect this port to your external gateway
E LAN2 Connector (RJ45) Connect this port to your local network, a network switch or a PC.
F OpenBMIP Connector (RJ45) Unused port for TVRO
G NMEA Connector (two pole) Use this port to connect (if available) the ACU to your vessels
compass. Observe correct polarity.
H NMEA Protocol Select Switch Set this switch according to the used NMEA protocol on your vessel
(RS232 or RS422/RS485).
Change only if you are instructed to do so by a technician.
I GPIO Connector Optional connector to extend the ACUs connectivity by two general
purpose inputs or outputs.
J LTE Connector Connect the LTE antenna to this port
K USB Port Use this port to communicate serially with the ACU
L Antenna RX (N) 1 Carries DC power from ACU to the Antenna
M, Modem RX (TNC) Unused Ports in TVRO system
Doc ID 0354 15.12.20
Page 17/33
Figure 5.2: ACU rear view