Eoslift M25S, Руководство по эксплуатации

Страница: 2 / 8

1.Technical Specifications
2.1 Remove 3 bolts (111) from the handle bracket (365).
2.2 Set handle (110) on the bracket (365), notice to allow the chain (114) and the adjusting bolts (116)
assembly to pass through the hole in the center of the bracket (365) and shaft (369).
2.3 Insert the 3 bolts (111) through the handle into the bracket (365), then tighten them securely.
2.4 Raise the lever plat (315) and insert the adjusting bolt (116) into the front slot, keeping the adjusting
nut (117) on the under side of the lever plat (315).
2. To Attach Draw-Bar to Pump Unit
(kg)
(mm)
(mm)
(mm)
(mm)
(mm)
(mm)
(mm)
2000 2500
200( or 190 )
85( or 75 )
1150 / 1220
540 / 685
160
Ø 8 0 x70(or Ø 7 0 x70) Nylon, Polyurethane
Ø 200(or Ø 180) Nylon, Polyurethane, Rubber
Capacity
Max. Fork Height
Min. Fork Height
Fork Length
Width Overall Forks
Individual Fork Width
Load Wheel Diameter
Steering Wheel Diameter
M20S M25S Item/type
3.To Adjust Release Device
On the draw-bar of this pallet truck, you can find the control handle (108) which can be regulated in three
positions :
Raise
- handle down
Drive position- handle in center position
Lower
- handle up, the lever moves back the drive position when released. If however they have been
changed, you can adjust according to following step:
3.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (117) on the adjusting bolt
(116) or adjusting screw (318) clockwise until pumping action does not raise the forks and the DRIVE position
functions properly.
3.2 If the forks descend while pumping in the DRIVE position, turn the nut (117) or adjusting screw
(318) counter-clockwise until the forks do not lower.
3.3 If the forks do not descent when the control handle (108) is in the LOWER position, turn the nut (117) or
adjusting screw (318) clockwise until raising the control handle (108) lowers the forks. Then check the DRIVE
position according to item 3.1 and 3.2 to be sure the nut (117) or adjusting screw (318) is in the proper
position.
3.4 If the forks do not elevate while pumping in the RAISE position, turn the nut (117) or adjusting screw (318)
counter-clockwise until the forks elevate while pumping in the RAISE position. Then check the LOWER and
DRIVE position according to item 3.1, 3.2 and 3.3.
1
1 Technical Specifications
2 To Attach Draw-Bar to Pump Unit
3 To Adjust Release Device
4 Maintenance
5 Safety Guidance
6 Transportation, Loading, Commission & Storage
7 Trouble Shooting
8 Parts List
Page 1
Page 1
Page 1
Page 2
Page 2
Page 4
Page 5
Page 6
CONTENTS