05
06
1
.
Hydraulic oil
Please check the oil level every six months and change the oil every twelve months. 32 #
hydraulic oil is recommended, with total volume of about 0.5 liters.
2
.
Remove the air
The air may enter into the pump because of transportation or pump in upset position. It will cause
the forks fail to be lifted when the finger grip control handle switched to the lifting position. The
air can be removed in the following way: pull the finger grip control handle (1-1) to the lowering
position and move handle up and down for several times.
3
.
Daily check and maintenance
Daily check and maintenance of the pallet truck can limit wear as much as possible. Special
attention should be paid to the wheels, the axles, as thread, rags, etc.To avoid block the wheels
and axles. The forks should be unloaded and lowered in the lowest position when the job is over.
4
.
Lubrication
All bearings and pivots are provided with long-life lubricants at the factory. You just need to fill the
lubrication points with long-life lubricants monthly intervals or after each time the truck is cleaned
thoroughly.
1 The truck should be parked with the forks lowered to min. height.
2 Check if the signs and warning labels on the truck are in place before using the truck each time.
3
Use original parts.
4 The waste liquid shall be place in special collection places for disposal.
5 Modifications or alterations to the truck, especially the safety device are prohibited.
6 Only customer service persons specially trained by our company can carry out maintenance
of the truck.
7 Thoroughly standardized maintenance is the most important preconditions to ensure stable
and reliable operation performance of the truck. Neglect of regular maintenance could result
in failure and malfunction of the truck and poses a potential threat to the safety of the staff and
operation.
Maintenance
1
2
3
1
-
1
Upper
Middle
Lower
2-3
2-4
2-6
On the handle of this pallet truck, you can find finger grip control handle(1-1) which can be regulated in
three positions :
Lifting-set the control handle at lower position. When lift up the hand pallet truck.
Middle position: set the control handle at middle position. When the operator need to move it.
Lowering: set the control handle at upper position. When lift down the hand pallet truck.
The handle moves back to the middle position when released
However if the truck cannot operate normally as above the three positions, you can adjust them according to the
following steps:
①
If the forks elevate while pumping in the Middle position, adjust the adjusting nut (2-4) on the adjusting bolt
(2-3) or screw (2-6) clockwise until pumping action does not raise the forks and the finger grip control handle
works properly Middle position .
②
If the forks descend while pumping in the Middle position,
the screw(2-6) or nut(2-6) counter
adjust
clockwise until the forks stop descending.
③
If the forks do not descend when the finger grip control handle (1-1) is in the Lower position,
adjust
the nut (2-4) or screw (2-6) clockwise until the forks. Then check the
Middle position according to steps
and
②
to make sure the nut (2-4) and screw(2-6) are in the proper
①
position.
④
If the forks can’t lift up when the finger grip control handle is in the lower position, adjust the nut
(2-4) or screw (2-6) counterclockwise until the forks lift up. Then check the function of the Lower
position and Middle position according to steps
,
②
and
③
are normal.
①
Adjusting the finger grip handle
M Series Hand Pallet Trucks
