10
Installation Instructions - Relay Box for Infrared Cabins
Identification
EN
2.1.1 Control unit
The Relay Box for Infrared Cabins can be operated with one of the follow-
ing control units:
EmoTec, EmoTec IR (software release R. 3.45 or higher)
EmoStyle, InfraStyle (software release R. 3.45 or higher)
EmoStyle i, InfraStyle i (software release R. 3.45 or higher)
EmoTouch 3 (also SteamRock Premium) (software release R. 2.06 or
higher)
Check your control unit’s software version. Update your software if it does
not match the specifications above.
Control units are not included in the Relay Box for Infrared Cabins‘s scope
of delivery.
For more information about the control unit, see the relevant operating
instructions and chapter Commissioning,
2.2 Intended use
The Relay Box for Infrared Cabins is designed to operate infrared emitters
and heating foils in infrared cabins. It must only be mounted on a wall. The
IR module unit must be used in order to operate infrared heating foils and
infrared emitters in a sauna cabin.
The Relay Box for Infrared Cabins is suitable for cabins used in private and
commercial settings.
Foreseeable misuse
The following are considered instances of foreseeable misuse:
The infrared heating foils do not have an integrated temperature sensor
with overheat protection.
The control and sensor cable plugs are plugged in incorrectly.
The cabin addresses are programmed incorrectly.
The unit is operated without knowledge of or compliance with the
safety instructions.
Operating, service and maintenance requirements are not observed.
The unit is operated after technical or other modifications are made to
the relay box.
The unit is operated by children or persons with reduced mental capac-
ity or by persons who have not been thoroughly instructed in its use.