SBM-IR Modul - Operating Instructions
25
Operation
3.4.1 Configuring during commissioning or after a reset
The basic settings must be defined to commission the unit. The program
guides you through the required steps.
The home screen automatically appears after not using the control panel
for 15 seconds. Settings that have not been saved are lost.
Defining the basic settings
1
Select a language and confirm.
2
Set the time and confirm.
3
Set the date and confirm.
4
Select the type of use and confirm:
a)
Private use
b)
Commercial use
Specific safety regulations apply to this setting. See 1.3 Operator
instructions,
In the sauna cabin, initial configuration involves additional steps, e.g.
heater selection, etc. These steps are described in the installation and oper-
ating instructions for the corresponding sauna relay box.
You must select and configure the IR intensity and/or IR temperature oper-
ating modes once the channel groups are configured.
See 3.3.2 Configuring the channel groups,
3.4.2 Configuring the channel groups
The settings are configured as shown in the example above.
Configuring the IR channel groups
1
: Select and confirm by pressing and holding until the code entry is
displayed.
a)
EmoTec: Press and hold the jog dial.
b)
EmoStyle: Press and hold the Enter icon.
