14
Operating Instructions - SBM-IR Modul
Operation
EN
3.3.1 Configuring during commissioning or after a reset
The basic settings must be defined to commission the unit. The program
guides you through the required steps.
The home screen automatically appears after the control panel has not
been touched for 10 seconds. Settings that have not been saved are lost.
Defining the basic settings
1
Select a language and confirm.
2
Set the time and confirm.
3
Set the date and confirm.
4
Specify the type of use and confirm:
a)
Private use
b)
Commercial use
Specific safety regulations apply to this setting. See 1.3 Operator
instructions,
If you use the EmoTouch 3 to operate sauna cabins and steam rooms in
addition to the IR cabin, initial configuration involves additional steps, e.g.
heater selection, cabin views, etc. These steps are described in the installa-
tion and operating instructions for the sauna and steam room relay boxes.
You can select and configure the IR intensity and/or IR temperature operat-
ing modes once the channel groups are configured.
See 3.3.2 Configuring the channel groups,
3.3.2 Configuring the channel groups
The settings are configured as shown in the example above.
Configuring the IR channel groups
1
Select the cabin.
2
Tap and hold
for 3 seconds.