10
Operating Instructions - SBM-IR Modul
Operation
EN
Operation
All cabin settings are made at the control unit. At least one cabin must be
set up for commissioning.
The term IR emitter refers to infrared emitters and heating foils in the fol-
lowing documentation.
In order to commission the cabin with the installed IR emitters, the cabin
must be switched on at the control unit. If the display is blank, the relay box
might be switched off.
An on/off switch is located on the left side of the relay box and the module.
Both switches must be switched on to configure the control system.
Position I:
Relay box is switched on.
The relay box is ready for operation in standby mode.
Position 0:
Relay box is completely switched off.
Parts of the circuit board are still energized.
Position II:
Cabin light is switched on, relay box is switched off.
Position for maintenance and cleaning.
