EOS IRS 40 RHK, Инструкция по сборке и эксплуатации

Страница: 23 / 38

23
EN
First make a rectangular cut-out in the cabin wall
as shown in the Fig. 5.
For the foot-zone radiator the cut-out should
be horizontal.
The wall above the radiator should be hollow
inside to let the hot air rise.
Draw the connection cable from the radiator
up to the ceiling through the duct in the cabin
wall. Pay attention that the cable connection
of the radiator must be oriented downwards.
Then insert the radiator into the prepared wall
aperture and secure it with the mounting screws
as shown in Fig 6 and 7.
For details and safety gaps please refer to the
illustrations shown in Fig. 4, 5, 6 and 7.
Installation
Fig. 5
Dimensions in mm
Front view Wall cut-out
with rear ventilation
ATTENTION!
Not suitable for installation in the cabin
ceiling.
Risk of fire due to heat congestion.
Fig. 6
Fig. 7
Flush-mounted installation
Vertical installation in corners
160 mm
171 mm
15 mm
50 mm
40 mm Wooden rail if necessary
Protective guard rail if necessary
Area behind the
radiator must be
well aerated
ATTENTION!
Do not install the IR radiator in direct
heat range of another IR radiator. Risk of
damages due to overheating!
171 mm
15 mm
90 mm
Installation example
Danger to life and risk of fire
due to overheating
If there is no or inadequate ventilation
behind and above the IR radiator, the
wood can overheat - risk of fire. Ensure
adequate ventilation. Do not block the
space above the IR radiator so that the
warm air can rise freely.
560
165
550
185
65
530
5
5
4.0
10
165