5
Remove the protective sensor cap
Press the On/Off button to power on the thermometer.
With a beep the screen will turn on and would display as
shown in figure 1 on the right
Direction for use
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 1
In approximately 2 seconds the device will be ready for
measurement and the screen will display an image of the
ear as shown in figure 2.
Insert the probe/sensor in to the ear canal. When using on
Children below 12 months, slightly pull the ear lobe back
and up to straighten the ear canal. Insert the sensor / probe
until it completely seals the ear canal.
Press the Scan / M button. At this moment, the ear image will
disappear from the display screen and a short beep will be
heard.
When the measurement is over, a long beep will be heard,
Release the Scan/M button and the measured reading will
appear on the display screen along with the ear image Please
see Figure 3.
To re scan / measure the temperature please wait 20 seconds.
Figure 2
Figure 3
Accessing Stored Measurements
While the thermometer is switched
off, press the ‘Scan/M’ button and
release it. The screen will light up.
press the ‘Scan/M’ button again to
read the memorized measurements
one by one starting from 1 to 10.
please see figure 4. Each time the ‘Scan/M’ button is pressed, the next saved
measurement will be displayed.
Figure 4
Press on the cover of the battery compartment and slide it down. insert the 2
‘AAA’ Batteries by matching the polarities: + (positive) and - (Negative) as marked
in the battery compartment. Slide in the battery compartment cover back.