INSTALLATION GUIDE
Figure 1.4
Figure 1.5
Figure 1.6
•
Visually check the seam between the conference
top pieces. If the seam is not aligned, first check if
each piece of the top is level.
•
Adjust the table base per the table base specific
instructions as needed to level the top.
•
If the surface is level and the seam does not align
between pieces, lightly push and pull on two pieces
of the conference top as shown in Figure 1.5 to
align the seam. Once the seam is in the correct
position, tighten down the tight joint closest to that
edge of the table with a ratchet. This step will
require 2 people, one to hold the table in place, and
one to tighten the tight joint connector.
•
Attach the conference top to the table base. If the
top has embedded braces, verify that none of the
screw heads interfere with the table base.
•
If some screw heads do interfere with the table
base, remove those screws as necessary.
•
Repeat these steps for each table seam, on both
sides of top.
3
12900 Christopher Drive Lowell, MI 49331
800.815.7251
Specifications subject to change without notice.
