6
Call 1300 369 273
www.enware.com.au
operating instructions
Instructions for all emergency equipment should
be readily accessible to maintenance and training
personnel.
1. Squeezing the trigger activates the drench hose.
2. Grab the trigger gun up from the bracket,
squeeze the trigger to start water flow, and
apply to body parts needing treatment.
3. To stop the water flow, simply release the
trigger.
4. To keep the water flow to stay on, slide the
holding ring over the trigger handle while
squeezing the trigger.
When servicing ensure that the water supply is turned OFF before disassembling the product.
troubleshooting
SQUEEZE TO TURN ON
RELEASE TO TURN OFF
USE HOLDING
RING TO KEEP
TRIGGER ON
PROBLEM
CAUSE
RECTIFICATION
Trigger Spray does
not turn off
Debris fouling ball seating
washer or stainless steel ball
Dismantle and clean SBA
Seating washer damaged or
spring broken
Replace components using spare part kit (Enware
Part Code FS077NS) or replace SBA (Enware Part
Code FS721S)
Piston jammed in open
position
Remove dome and piston from SBA. Clean piston
assembly and re-grease piston o-rings
No flow from trigger
spray outlet
Water supply turned off
Turn water on
Seating o/ring damaged
Replace o-ring using spare part kit or replace SBA
Debris fouling inlet or outlet
ports of SBA
Dismantle and clean SBA and outlet aerator.
Replace if necessary
Water discharge
from top of trigger
spray dome
Piston o-rings worn
Replace o-rings and re-grease spindle with
service kit or replace SBA