2
Call 1300 369 273
www.enware.com.au
technical information
installation instructions
BEFORE PROCEEDING WITH INSTALLATION
Ensure all supply lines are flushed thoroughly to remove
debris prior to the installation of this product as per
AS/NZS 3500.1. Strainers (40 mesh) are recommended if
debris is an ongoing problem.
1.
Ensure water lines have been thoroughly flushed and
are free of debris.
2.
Fit the dress ring to the bubbler and engage the
anti-rotation pins in the pin-holes.
3.
Screw the bubbler to the desired position on the ½”
MI thread without sealant or thread tape and mark the
countersunk holes.
4.
Remove the bubbler and drill holes to accept a suitable
countersunk screw or fixing.
Note: the holes are offset to allow easy access of a
screwdriver
5.
Seal thread using thread tape (or other approved
means) and screw the bubbler into position with the
dress ring fitted and anti-rotation pins engaged.
6.
Turn water on and activate the bubbler and bottle filler
to bleed any air that may be trapped in the bubbler.
Check the connection point for leaks. Fit screws to
secure the bubbler in place.
7.
Activate the bubbler and bottle filler a number of
times, the bubbler flow stream will settle to a height
50-100mm above the mouthguard and is now ready to
use.
57.5
10
100
26
130
200
180
110
85
22
33
16
55
10
5 TYP
DEPTH)
SPACE FOR
CIRCUIT BOARD
(REQUIRES 30mm
COVER PLATE
OUTLINE
IMAGE 2
Bubbler Inlet Connection
15mm (1/2" BSP)
Spring Loaded SBA (Spindle)
5/8” BSP
Recommended Working Pressure
Range
100 – 500 kPa
(Max. 500 kPa – AS3500)
Flow Rate (Drinking Fountain)
2 – 2.5 L/min approx.
with flow stream set
50mm above guard top
Recommended Operating
Temperature Range for Drinking
Fountains
5 – 30 °C
COMPLIANCE
Enware products must be installed in
accordance with the Plumbing Code of
Australia (PCA), AS/NZS3500 and the
manufacturer’s instructions. Installations
not complying with PCA, AS/NZS 3500 and
the manufacturer’s instructions may void
the product and performance warranty
provisions.
This product must be installed and
commissioned by a qualified plumber.
57.5
10
100
26
130
200
180
110
85
22
33
16
55
10
5 TYP
DEPTH)
SPACE FOR
CIRCUIT BOARD
(REQUIRES 30mm
COVER PLATE
OUTLINE
IMAGE 1
