R e p l a c i n g B at te r i e s
27
®
Door/Window
Contacts
WLS925L-433
To remove the cover of the universal trans-
mitter, squeeze both sides of the unit where
the notches are. Pull to release the cover.
Use care when installing the battery and
observe the correct polarity (see diagram).
Use only an Eveready Lithium Energizer No.
EL123AP battery.
Motion
Detectors
WLS904-433/WLS904P-433
Remove the motion detector from its mounting plate by
holding the detector by its sides and pushing up.
Remove the old batteries and install four fresh Eveready
Alkaline Energizer AAA batteries. Be sure to observe cor-
rect polarity when inserting the batteries. Replace the
detector on its mounting plate, making sure it snaps into
place.
WLS914-433
Remove the motion detector from its mounting plate by holding the
sensor by its sides and pushing up. Install four fresh Eveready Alka-
line Energizer AA batteries. Be sure to insert the batteries in the
proper orientation. Replace the sensor on its mounting plate, making
sure it snaps into place. After the batteries are installed, the detector
will take 60 seconds to warm up. During this time the LED will flash.
Glassbreak
Detectors
WLS912-433
Remove the detector from its mounting plate by
pushing the detector in the direction shown at
right.
Install the three Eveready Alkaline Energizer bat-
teries, with the correct polarity, as shown at
right.