Envision Matrox Concord, Руководство по установке и аппаратным средствам

Страница: 6 / 40

6 Chapter 1: Introduction
Matrox Concord
The Matrox Concord family is comprised of two types of network interface boards:
the G-series boards, which are Gigabit ethernet network interface boards (NICs),
and the F-series boards, which IEEE 1394b network adapters boards. For image
acquisition from supported network cameras, these boards are pre-licensed for use
with the Matrox Imaging Library (MIL) GigE Vision and IEEE 1394 IIDC
drivers, respectively.
Matrox Concord G-series
The Matrox Concord G-series boards are basically 10/100/1000BaseT (Gigabit
or GigE) NICs that provide optimum support for the GigE Vision camera
interface standard. There are two versions of the G-series boards: a conventional
32-bit PCI version called Matrox Concord GX, and a x1 PCIe version called
Matrox Concord GE.
Using the MIL GigE Vision driver, Matrox Concord can capture video from
multiple
1
cameras compliant with the GigE Vision specification.
Unlike generic NICs, Matrox Concord G-series with MIL does not require
manually adjusting advanced driver properties. Through MIL, the Matrox
Concord G-series boards are optimally configured to minimize GigE Vision
1. Refer to MIL documenation for the nu
m
ber of cameras from which Matrox Concord
can simultaneously capture video.
MAC/Link
Layer
Controller
Physical
Layer
Controller
Matrox
Concord
G-series
Host PCIe/ bus PCI
MIL license for
MIL IEEE 1394 IIDC driver,
MIL fingerprint, and
Supplemental MIL license storage
Rj45
10/100/1000 Mbps
ethernet connector
x1 PCIe (GE)
(Upto 250 MB/s)
5 V/3.3 V, 32-bit
Conventional PCI (GX)
(upto 260 MB/s)