Envirovent PROFILE-100, Инструкции по установке и подключению

Страница: 7 / 12

PROFILE-100 AXIAL EXTRACTOR FANS
Suitable for bathroom applications
INSTALLATION
IMPORTANT: before installing and wiring the unit, ensure that the mains supply
is disconnected.
PROFILE-100 should only be used in conjunction with fixed wiring.
Fig.1
1
– Grille
2
– Fixing screw for front cover
3
– Connection terminals
4
– Outlet
5
– Cable entry point
The PROFILE-100 is suitable for panel, ceiling or wall mounting (for wall
mounting applications using EnviroVent wall kit) (fig. 2).

Drill a hole in chosen position in the panel, ceiling or wall of size Ø105mm in
diameter. If the unit is to be installed with ducting, use standard duct size
Ø100mm.

The hole for the duct should be angled downwards to prevent rainwater
running through the duct into the unit.

Loosen the screw (2), which holds the grille in place (1) and remove grille.

Place the extractor against the internal wall or ceiling. For a wall mounted
fan the terminal block should be at the bottom. Mark the 4 screw hole
positions. Drill, plug and screw the extractor in position.

Check that the wall tube is not distorted and that the impeller turns freely.

Once the cable has been introduced through one of the cable points (5), fix
to the wall.

This fan must be installed by a competent person. Complete electrical wiring
of fan as outlined in the Wiring Instructions below. Then refit the grille and
tighten the screw (2).
WIRING
IMPORTANT: ENSURE THAT THE MAINS SUPPLY IS SWITCHED OFF
BEFORE MAKING ELECTRICAL CONNECTIONS.