Envirovent POWER-170, Инструкции по установке и подключению

Страница: 3 / 11

POWER-170 & 250 CENTRIFUGAL EXTRACTOR FANS
Suitable for kitchen applications
Thank you for placing your confidence in EnviroVent by buying this product. It
has been manufactured in accordance with current technical safety regulations,
production and quality standards as laid down by the international Quality
Standard ISO 9001. Please read this instruction booklet carefully before installing
or operating the product. It contains important information on personal and user
safety measures to be followed whilst installing, using and carrying out
maintenance work on the equipment. Once the product has been installed, please
pass this booklet to the end user.
Check that the product is in perfect condition while unpacking. Any fault or
damage caused in origin is covered by the
EnviroVent guarantee. Please make
sure that the product corresponds to the one you have ordered and that the
details on the instruction label fulfil your requirements.
IMPORTANT:
BE SURE TO HAVE READ AND UNDERSTOOD THESE INSTRUCTIONS BEFORE
BEGINNING THE INSTALLATION PROCESS
SAFETY AND RECOMMENDATIONS:
SITING A POWER 170 OR 250
All wiring must comply with Building Regulations and the current I.E.E. Wiring
Regulations (BS7671) or the equivalent standards for your country. The final
installation should be examined and tested by a competent person.
Do not install near sources of heat in excess of 40°C.
Do not site fan near obstacles which can obstruct airflow.
Position away from any source of water spray. Do not site in a shower enclosure.
Ducted Applications. In circumstances where an excessive amount of moisture is
present in the air, then a condensation trap will need to be installed in the exhaust
duct.
Horizontal ducts should fall away from the fan unit . Ducts passing
through an unheated roof void should be insulated.
POWER-250 HP & POWER-170 HP. These fans are fitted with automatic
electronic humidity sensors. They should ideally be mounted on an inside wall
between the major moisture source and the door to the other rooms of the building.
Do not site closer than 100mm to cupboards, etc. Do not site above a radiator or
other heat source. We recommend the HP models are mounted as shown in Fig.
2.1.
2