5-in-1 Remote and Receiver Manual
EnvironmentalLights.com • P: 888.880.1880 • 11235 West Bernardo Ct., Suite 102, San Diego, CA 92127
© Environmental Lights
2
5-in-1 Receiver Wiring
1.
Confirm that the power supply voltage matches the LED Strip Light voltage and that the power supply is unplugged.
2.
Connect the power supply to the 5-in-1-Receiver using either the screw terminals or the DC barrel input. Do not use the DC
barrel input if using more than 5A of strip light. P
ower supply positive and ground should be connected to “V+” and “V
-
”
terminals respectively when using the screw terminals.
3.
Connect the LEDs and power supply to the 5-in-1-Receiver using the screw terminals. The positive wire should be connected
to the “
V
+” terminal. Connect LED negatives to output channels 1
-5 as appropriate for the installation. Follow the label and
use the wiring diagrams below to put the correct wire into each screw terminal. Do not connect more than 6A per channel or
over 15A total.
For 5 channel control, connect red to R, green to G, blue to B, cool white to CW and warm white or amber to WW. The positive wire
connects to the V+ terminal. Once connected, press the switch button until the indicator light shows blue.
For 4 channel control, connect red to R, green to G, blue to B, and the white to W. The positive wire connects to the V+ terminal.
Once connected, press the switch button until the indicator light shows green.
