QUICKTOX FLEX INCUBATOR INSTRUCTIONS
Remove incubator base and block from each of their respective boxes. Assemble by placing block into the
incubator base, and connecting the power cord. Be sure the unit is on a flat surface away from heat
sources, windows, etc.
Note. The block will fit snugly in the base. To make it easier to insert, try to make sure it is squared up
while getting started. It may take some force to get the block to slide in. Once inserted, continue to press
down so that the bottom of the block is in complete contact with the plate inside the base.
To set the incubator, flip the switch on
the back to the 'on' position. Unit will do
a system check, and the display will
default to P1 (program 1), indicating its
current temperature.
Use the "Shift" key (
) to move the cursor
over to the appropriate spot; use the up
and down arrows (
) to set the "tens"
digit to "2". Use the Shift key again to
move the cursor to the "ones" digit and
enter 2 as well. This sets the preferred
Though you should
not ever need to,
there is a tool
included in the
incubator base box
that can be inserted
and screwed into the
block to provide a
handle for pulling it
out of the base.