07-02317C EB AV
1
EnviroBoss
Owner’s Manual
EnviroBoss AV Airmover
15180 Josh Wilson Road, Burlington, WA 98233, USA
Phone: +1 800-932-3030
Fax: +1 360-757-7950
www.EnviroBoss.com
The EnviroBoss AV produces high velocity airflow for ventilation and air circulation.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING!
To reduce the risk of fire or
electric shock, do not use this fan with any
solid-state speed control device.
WARNING!
Unit must be grounded. Do not
use with an extension cord. Connect only to an outlet provided
with a ground fault interrupting device.
WARNING!
Never operate a unit with a damaged power cord, as
this may lead to electrical or fire hazards. If power cord is
damaged, it must be replaced. Use only replacement parts
authorized by EnviroBoss.
WARNING!
Do not touch grills when unit is operating.
NOTICE:
Keep motor dry. For indoor use only.
NOTICE:
Unplug when not in use or when moving unit.
NOTICE:
Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
NOTICE:
Always operate the unit on a stable, level surface so it
cannot fall and cause injury.
WARNING!
Do not alter or modify the EnviroBoss AV in any
way. Use only replacement parts authorized by EnviroBoss.
Modifications or use of unapproved parts could create a hazard
and will void the product warranty. Contact an authorized Dri-Eaz
distributor for assistance.
WARNING!
a) Do not operate any fan with a damaged cord or plug. Discard
fan or return to an authorized service facility for examination
and/or repair.
b) Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
BEFORE YOU BEGIN
Warranty
If you determine service is required, have your equipment model,
serial number and original proof of purchase available and call
your distributor for assistance with obtaining a return material
authorization (RMA).
OPERATING INSTRUCTIONS
1. Unwrap the cord and plug the unit into a standard 115V
GFCI-protected outlet. CAUTION: Be sure switch is in the
off position before connecting unit to power outlet.
2. For ventilation, direct the EnviroBoss AV outlet where
desired. For drying, direct the outlet toward the surface to be
dried. Secure the airmover orientation by tightening the
knobs on either side of the unit.
3. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
Fig. A: Parts Identification
Cord wrap. Wind cord
around housing in groove.
Secure cord with plug clip.
Variable speed control
Outlet grill. Keep
clear of obstructions.
Power outlet socket.
Tighten knob to secure
fan orientation.
Inlet grill. Keep clear
of obstructions.
Carry handle
Circuit breaker reset switch.
Hour meter.
