Electronic
ignition module
Maintenance And Service
c
Leaning
t
he
g
Lass
:
When the fireplace has cooled
, remove the face of the fireplace along with the glass. See
M
aintenance
a
nd
S
ervice
- G
laSS
d
oor
r
eMoval
.
Check the
gasket material on the back of the glass, making sure that it
is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all
fireplaces. However, this condensation can allow dust and lint to cling to the glass surface. Initial paint
curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need
cleaning about two weeks after installation.
Use a mild glass cleaner and a soft cloth
;
abrasive
cleaners will damage the glass and plated surfaces.
Depending on the amount of use, the glass
should require cleaning no more than two or three times a season.
Do not clean the glass when it is
hot.
c
Leaning
t
he
F
iRebox
:
Remove the logs carefully, as they are very fragile. Gently remove all the embers and rock wool and
place on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off the
logs and remove any lint from the burner and pilot. At this time, inspect the burner pan for cracking or
severe warping. If a problem is suspected, contact the dealer. C
heck the logs for deterioration or large
amounts of soot; a small amount on the bottom side of the logs is normal. Replace the logs and embers
as in the
l
oG
S
et
and
e
Mber
i
nStallation
section.
If new/more embers and rock wool are required, contact
your nearest ENVIRO dealer.
c
hange
b
atteRy
in
i
gnition
m
oDuLe
:
Figure 5: Electronic Ignition Module
Location.
10
If the unit does not spark when lighting, the battery in the
electronic ignition could need replacing.
Located on the left hand rear corner of the unit is a small
rectangular hole. Located here is the electronic ignition module
(see Figure 5). Remove the battery cover, located on the left
side of the module, and replace the AA battery.
Reinstall the battery cover and check for spark by depressing the
pilot knob located on the control panel.
R
ePLacing
the
g
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see
P
artS
l
iSt
- c
oMPonentS
). Wear gloves when handling damaged glass door
assembly to prevent personal injury. When the glass door assembly is being transported, it must be
wrapped in newsprint and tape and/or a strong plastic bag. Do not operate with the glass front removed,
cracked or broken. Removal and replacement of the glass from the door
must be done by a licensed or
qualified service person.
The glass must be purchased from an ENVIRO dealer. No substitute
materials are allowed.
Содержание westport-steel
Страница 46: ...Notes 46...