MMG1
2/2
50.0037.01.00
ATTENTION:
There can be only one module with priority 1. Remember that every module containing
PRIORITY
information must be installed on the same chassis.
If you configure the module to operate in ALAR. mode, define now the zones to which the message has to be sent by means
of the jumpers highlighted in nr.
3
. For example: If you wish the module to act in zones 3 and 5, insert two jumpers at
position J111 and J113.
Choose whether the message should be announced repeatedly or just once (nr.
4)
.
Insert and screw the module and the chassis together in the front and back panels.
Connect the data buses (Flat 10- and 20-way cables) to the connectors marked with nr.
5
in the figure on next page.
Link together the front and back panel. In this case you will have to connect following connector pair marked with nr.
6
:
J122-TS102.
The connector marked with nr.
7
serves to connect to the consoles MCT12 module from which you want to record a
message. Both connectors (J123 and J124) are shunted and it is irrelevant to connect the MCT12 to one or the other. The
unoccupied connector can be used to connect another MMG1 module to the same console, if you wish so.
Once the complete installation of one or various chassis and the peripherals connections to ENVIRO has been carried out,
you should adjust the volume of this module so that the
SIGNAL LEVEL
LED lights up green while talking normally. As the
final step in the modules configuration, you may wish to adjust the tone controls.
OPERATION
To record a message, first select the audio source from which you want to record with the switch button found on the
front panel: CNSL (raised button) means that the message will be recorded from the selected console without having to
press the PAGE key or MIC/LIN (pressed button), in this case, the message will be recorded from a microphone connected
to the front panel or from an audio source connected to the Line input on the backside.
To perform the recording, keep the REC button pressed during the recording time.
The playback of the message can be activated from the modules front panel (PLAY/STOP) or remotely via press keys,
programmed timers, programmed alarms, etc.
MMG1 MODULE
1
3
4
5
6
PRIORITIES:
Priority 1: J103-J106
Priority 2: J104-J107
Priority 3: J105-J108
2
7