Enviro Carbon Pro Series, Руководство пользователя

Страница: 16 / 22

Enviro Water Products Pro Series Water Filter and Salt
Free NaturSoft
®
System
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Rev A
Page 1 6
www.envirowaterproducts.com
What to Expect with your New Salt Free NaturSoft
®
System
If you have never had a water softener /conditioner :
Immediately after the installation you will experience naturally soft water. All detergents will work better
with treated water and you will be able to reduce the amount you use. However, there are mineral deposits
and scale coating the inside of your pipes and fixtures. Over the first few weeks, this scale will dissolve,
detach itself from the pipes, and come out of your faucets. This de-scaling process is temporary and will
steadily diminish. During these first weeks, you will notice:
n
Reduced softness of the water.
This will be particularly evident when using hot water. The water
can pick up more than ten grains of mineral content per gallon between the Pro
NaturSoft
® system
and the faucet as it travels through the water heater and the plumbing.
n
Mineral silt in the water.
Since the existing limestone scale is softened and dissolved as part of the
Pro
NaturSoft
® effect, it will detach in small chunks ranging in size from very fine silt to pieces larger
than a grain of sand. The larger pieces may be big enough to build up in the aerator screens of your
fixture. Considerable silt-like accumulations may be visible on the shower heads, so clean them weekly
for the first four weeks. Higher flow rates will shear off more of the existing scale than will lower flow
rates. De-scaling activity will be most obvious in bathtubs, which have high flow and hot water. You
may see milky water with sand-like grit, and possible sediment or iron in the bath tub.
The water line supplying fixtures which experience the most use will be cleaned the quickest and will be
the first to return to providing you the full benefits you experienced immediately following installation;
rarely used fixtures will take longer.
If you had a traditional water softener:
A traditional water softener turns dissolved mineral hardness (calcium bicarbonate) into dissolved
sodium bicarbonate. The Pro
NaturSoft
® technology maintains the healthy mineral content of the water
without adding the bicarbonate. You will notice:
n
The water does not feel as soft.
The absence of the calcium and the presence of sodium
bicarbonate makes the water feel slick and slimy. If you miss the slick feeling, add some baking soda
(sodium bicarbonate) to your bath.
n
The water spots are more visible.
A water softener replaces calcium with sodium. The water
spotting that a traditional water softener leaves behind is a salt haze that wipes off very easily and is
far less noticeable than spots caused by minerals. The Pro
NaturSoft
® treatment results in reduced
spotting compared to untreated water, but more visible spots than produced by traditional, chemically
treated softened water. The Pro
NaturSoft
® mineral spots are much easier to clean than spots from
untreated water.
n
Soap curd forms with certain products.
Oil-based soaps like Ivory will react with calcium minerals
to form a sticky film. Detergent-based cleaners like shampoos, shower gels, dish soaps, and laundry
detergents will react very slightly or not at all. All detergent will work better with treated water, but
you will notice very little improvement when using regular bar soap or oil-based products since the
minerals are largely still able to react with the fats in the soap to form the curd.
n
There is some mineral silt in the bathtub.
Depending on the water chemistry of your water
supply, you may still have some scale deposits in your plumbing system.