R
EPLACING
G
LASS
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see
P
ARTS
L
IST
- C
OMPONENTS
). Wear gloves when handling damaged glass door
assembly to prevent personal injury. When the glass door assembly is being transported, it must be
wrapped in newsprint and tape and/or a strong plastic bag. Do not operate with the glass front removed,
cracked or broken. Removal and replacement of the glass from the door
must
be done by a licensed or
qualified service person.
The glass must be purchased from an ENVIRO dealer. No substitute
materials are allowed.
To Replace:
Open door, and remove the glass carefully. Install the new piece of glass with the large bulb
in the gasket tape against the unit. Place the joint in the tape in a bottom corner. Close door.
G
LASS
D
OOR
R
EMOVAL
:
Maintenance And Service
Figure 5. Removing inner glass door.
9
Turn unit off and wait until the appliance has cooled down.
Remove the cast iron top from the unit by lifting straight up. Lift
the two door handles located on either side of the door and lift
the glass door assembly straight up and out. Carefully open the
two doors and remove if necessary.
Ensure the door is properly fastened after cleaning before
attempting to re-light the appliance.
B
URNER
R
EMOVAL
:
1. Remove the glass as shown in the
M
AINTENANCE
AND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
.
2. Carefully remove the log set and ember material.
3. Remove the two (2) screws at the back of the fire
box that hold the log support tray in place (see
Figure 6). Remove the support tray from the fire
box
4. Remove the screw located on the right side of the
burner that holds the burner to the chassis inside
the fire box. Remove the burner tray from the
firebox.
Figure 6. Removing log support tray.
