11
12
TROUBLE-SHOOTING
Deep Cleaning
Noisy functioning (audible loud buzzing sound) is a sign that your Ionic Pro
®
Compact
ionic air purifier is overdue for a complete clean-up of the collection blades and the internal
ionizing wires. The internal ionizing wires must be kept clean to ensure silent and normal
operation.
For deep cleaning, follow both the “TO CLEAN THE COLLECTION BLADES”
& “TO CLEAN IONIZING WIRES” sections.
IMPORTANT: MAKE SURE THE THOROUGHLY CLEANED AND DRIED COLLECTION BLADES ARE PROPERLY INSERTED, THE
REMOVABLE CAP IS BACK IN ITS ORIGINAL POSITION, AND THE WIRE CLEANING MECHANISM IS BACK IN ITS ORIGINAL
POSITION BEFORE RESUMING USE—OR THE UNIT WILL NOT FUNCTION.
Cleaning External Surfaces
Over time, some particles and dust may accumulate on the external surfaces of your Ionic
Pro
®
Compact ionic air purifier. If this happens, turn off and unplug the unit. Mix one
ounce of laundry bleach with five ounces of water and apply sparingly with a sponge to wipe
the outer case surfaces. Do not allow water to slip into the internal parts of the Ionic Pro
®
Compact ionic air purifier as this could damage its functioning and may result in injury to
you. Allow the unit to dry for at least 24 hours before resuming use.
TROUBLE
Indication/Setting light
not on
Red CLEAN light is on
Excessive noise
generated*
Collection blades do not
go back in
Indication light does not
go on
*See “Cleaning & Maintenance” section
Machine is unplugged. ON/OFF
button has not been pressed.
Too much dust has
accumulated.
Too much dust has
accumulated or internal parts
are wet.
Improper orientation.
Collection blades are not
completely inserted.
Wire Cleaning Mechanism is not
completely inserted.
Collection blades are jarred or
removed suddenly.
Red light may go on if the unit
just needs to be “reset”.
Check to see if plug is
loose. Press the ON/OFF
button.
Turn off, unplug and clean using
instructions from the “Deep
Cleaning” section.
Clean and dry blades and
ionizing wires thoroughly*.
Keep the machine dry.
Reverse blade orientation.
Check to see that the blades are
completely seated in housing.
Check to see that Wire Cleaning
Mechanism is completely
seated in housing.
Remove and re-insert
collection blades and press
“on” button to reset.
Press “on” button to reset.
REASON
TROUBLE-SHOOTING
TROUBLE SHOOTING
CLEANING & MAINTENANCE
CA200_ENV_050511.indd 11-12
5/10/11 10:08 AM
