1.Safety Instructions
1
2
Enventor
LASER LEVEL
INSTRUCTIONS MANUAL
WARNING
WARNING
ATTENTION
NOTE
User Guide, Maintenance and Care
：
EN
Thank you for purchasing Enventor Y011G/Y011R Laser Level. Before using the product,
please read this manual thoroughly to ensure proper use.
Please read thoroughly and comply with the Safety Instructions and User Manual before
using this product. Failure to read and follow may void the warranty.
Read all instructions prior to operating this laser tool. Do not remove any labels from
tool.
• While the product is in operation, be careful not to expose your eyes to the emitting
laser beam . Exposure to a laser beam for an extended time may be hazardous to your
eyes.
• Do not attempt to view the laser beam through optical tools such as telescopes as
serious eye injury may result.
• Do not disassemble or modify the laser in any way. Modifying the tool may result in
hazardous Laser Radiation Exposure.
• Do not operate the laser around children or allow children to operate the laser. Serious
eye injury may result.
• An exposure to the beam of a Class 2 laser is considered safe for a maximum of 2
seconds. Eyelid reflexes will normally provide adequate protection.
• The following label/print samples are placed on the product to inform of the laser class
for your convenience and safety.
• When not in use please power OFF the tool and place the pendulum lock in its locked
position.
• The laser tool is sealed and calibrated at the plant to the accuracy specified.
• It’s recommended to carry out an accuracy check before its first use and periodic
checks during future use, especially for precise layouts.
• Do not store the laser tool in direct sunlight or expose it to high temperatures.
• Exterior plastic parts may be cleaned with a damp cloth, NEVER use solvents. Use a soft,
dry cloth to remove moisture from the tool before storage.
• Do not dispose of this product with household waste.
• Please recycle in line with local provisions for the collection and disposal of electrical
and electronic waste under the WEEE Directive.
CLASS II LASER PRODUCT
COMPLIES WITH CFR 1040.10 AND 1040.11
Max. Power Output: <1mW
Wavelength: 505nm-660nm
LASER RADIATION:
DO NOT STARE INTO BEAM.
DO NOT DIRECT EYE EXPOSURE.
AVOID VIEW WITH OPTICAL INSTRUMENTS.