Hyperion User Manual
51164
For latest version visit:
www.enttec.com
January 19
ID: 3809208
16
During step one and two: status LED will continue to blink. At step three, status LED will switch off for 30
seconds, then turn amber for roughly 10 seconds.
It could take between 30-60 seconds for firmware update to complete. It is important, that you do not
interrupt the firmware update procedure at any time.
Once restart is complete, status LED should start blinking – this shows it’s ready.
In case a bad firmware update was attempted, the following error screen will be shown:
If the page does not refresh, please click the link at the bottom of the message, to load the Home page.
