Aleph2 ET DX4 Manual
50952
www.enttec.com
4
ID:
1552792
MASTER DIMMER (CH7)
drives the master intensity of all
the outputs. 000 the lowest intensity 0% (light will be
OFF, regardless of other channel values) and 255 the
highest, allowing 100% (maximum).
Presets Menu
The Aleph2 ET DX4 has 64 available slots where the user
can record custom colours from DMX. These can later be
activated from the menu. Presets turn the ET into a
stand-alone fixture, where 64 different colours can easily
be triggered on-site, without the need of DMX.
It is also possible to record user personalised Presets on
any of the 64 memory slots, overwriting the default ones.
RECORDING CUSTOM PRESETS:
To record your own colours, please scroll to the desired
slot (from 01 to 64), feed the desired data through the
DMX port until you are happy with the look. Then press
the SET key to overwrite the preset.
Pre-Set
Factory Default
Colour
01
All channels OFF (Default on Start-Up)
02
Red
03
Green
04
Blue
05
Neutral White
06
RGB Yellow
07
RGB Purple
08
RGB Cyan
09
5000K White
10
6000K White
11
6500K White
12
Pink
13
Pink1
14
Violet
15
Dark Violet
16
Crimson
17
Royal Blue
18
Aqua Marine
19
Slate Blue
20
Turquoise
21
Lime
22
Golden Yellow
23
Orchid
24
Salmon
25
Coral
26 to 64 slots are available for user custom colours
IMPORTANT NOTES:
When the light is powered on, it will automatically take pre-
set 01 as the default power on value, if the Lamp On Mode
setting is ON. This feature is handy for the user to set up the
desired colour combination for the fixture to start every
time it is powered up.
Note that the strobe feature is NOT a supported preset.
Any incoming DMX data will override the Presets, so ensure
that there is no DMX data coming in before navigating this
menu intending to playback the different colours.
Running the Factory Defaults RDM command will restore all
the Presets to the original values and user recorded Presets
will not be recoverable
.
Lamp On Mode Menu
This setting instructs the DX4 what to do after a power up
sequence.
If DMX or OFF settings are chosen, the DX4 will stay off and
will wait for DMX instructions.
When Lamp On Mode = ON the DX4 will power up and then
output whatever look has been recorded in slot 01 of the
Presets. Please notice that any incoming DMX will override
this preset, as DMX takes the highest precedence.
PWM Frequency Menu
The PWM driving frequency can be adjusted. This might
have an impact on the way some cameras respond to the
light emitted by the A2 ET DX4.
Backlight Menu
The NORMAL setting will turn the display green back light
on after any key operation. It will turn it off after a 15 sec-
onds of in-activity. The ON setting will keep the back light
always on. The OFF setting will keep the back light always
off, regardless of any operation.
Factory Defaults Menu
Running the Factory default sequence will reset all the user
configurable parameters, including DMX address, presets,
Personality, Lamp On mode, Etc.
