DIN PIXIE (73539)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
6
|
ID: 5935565
Document Updated: Feb 2022
Devices
This page provides information about the DIN PIXIE’s state and the ability to configure the device.
This will display:
Devices Serial Number
Devices Firmware version
Device Type
Device Capability
DMX Personality: Choose between Personality Modes (see
Functional Features within the document)
Start Address: Offset the DMX start address. The increments
are based on Pixel Ordering (RGB increments of 3, RGBW
increments of 4).
LED Stop Protocol: Choose the relevant protocol to work
with your Pixels (more information on this can be found on
our website).
Run Show on DMX Loss: If no DMX signal is received for 3 seconds, any standalone show saved on the DIN PIXIE
will be played back.
Blackout Output: As the last values received are held on the Pixels, if no DMX or USB signal is received for 30
seconds, the channels will be set to 0.
Pixel Ordering: By default, the DIN PIXIE is set to RGB. It is recommended that you set this to your Pixel color
order. These orders are any combination of RGB and RGBW. If the programming has been done with a different
pixel order, you can use this to make the change within the DIN PIXIE, saving having to re-program.
Firmware Update
Firmware update
The Firmware update procedure can be used to:
Update to the latest feature set.
Reset DIN PIXIE if it ever gets stuck or stops responding. (error mode).
The following steps will explain the firmware update procedure:
1.
Within PRO-Manager Device Tab, at the bottom of the screen is a drop down to select a default firmware option
or download a version from the ENTTEC website and locate it manually with ‘Choose File’.
2.
After selecting the firmware file, click on the “Update Firmware” button and let the update proceed. Do not
remove the USB cable until the update is complete. The update progress is displayed on the webpage.
3.
Once Finished, the page will automatically refresh, and device information will be updated to reflect the updated
firmware.
SEND
PRO-Manager can be used to test the output of the DIN PIXIE. The test output can be sent in the following ways:
“
Test Patterns” and select one of the pre-programmed test patterns to test the DMX output
“Live Art-Net” which will start listening for an Art-Net Broadcast though the loopback IP address (127.0.0.1).
