To
enter
programming mode (default master code 0000):
press
Error code:
If at any time you make an error the unit will
flash and beep 5 times. If this happens the unit will return to
the start and expect you to re-key the sequence.
To
change the master code
, for example to 8951
(up to 8 digits allowed)
LED status Sound
To
leave
programming mode:
press
To
leave
programming mode press
repeat
to confirm
press
press
To
add code to relay 1
, for example to 5623
(up to 8 digits allowed)
repeat
to confirm
To
add code to relay 2
, for example to 4455
(up to 8 digits allowed)
repeat
to confirm
To
add code to both relay 1 and 2
, for example to 2589
(up to 8 digits allowed)
press
press
press
press
press
press
press
repeat
to confirm
To
delete a code,
for example to 5623
repeat
to confirm
repeat
to confirm
To
change relay 1 time,
for example to 4 seconds (range 0-20, 0=toggle mode)
To
change relay 2 time,
for example to 12 seconds (range 0-20, 0=toggle mode)
To
turn keypad tones off
or on
To change the unit settings
you must be in programming mode
. The yellow LED
indicates the unit is in programming mode; if it is not on you cannot change any settings.
To
return unit to factory defaults
(be careful, all codes will be deleted)
The Entryphone CA8 is a coded access unit that can be
supplied as a stand-alone unit or incorporated, to special
order, into an Entryphone entrance unit.
Features include:
• 1-8 digit access codes
• Master code to programme the unit
• Up to 32 access codes, each operating either or both relays
• Two 6 amp relays with change-over contacts
• Anti-hack 30 second lock-out after 5 incorrect codes
• Non-volatile memory in case of power failure
• Confidence LED and beep (selectable)
• Back-lit keypad
• Relay output times 1-20 seconds and toggle mode
• Tamper-switch
• Input Supply 12/24 V AC or DC
• Power Consumption 7mA min. / 250mA max
• Operating temperature -20°C to + 50°C
Unit operation:
A user operates the unit by entering a valid programmed code
followed by the star key. Depending on the set up for that code
the unit will operate either or both the relays for the length of
time set for that output. Refer to the programming instructions
to set the parameters.
Code Input
Relay 1 Relay 2
Beep
Validate
Error:
If you key a wrong code, the unit will flash
and beep five times.
Five invalid entries will cause the keypad to flash and for the
unit to stop accepting further attempts for 30 seconds.
No.
Name
Code
R1
R2
M
Master
0000
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Programming record list
Please complete and keep in a safe place. Please remember to
change the master code from its default of 0000.
Programming Instructions