22
IP2288EN
EN
Output
Value of
accessories
Description
RDX
6ZENRS
ZENPRS
The control panel is fitted with a housing for modules of the 6ZENRS
radio receiver type (433.92 MHz).
Can be replaced with a module of the ZENPRS radio receiver type (868.35
MHz).
When using slot-in radio boards, remove the RDX module. The display
will show
.
WARNING: the modules must be inserted and removed with the power
supply disconnected.
COM
BIXM R2
COM - This allows the functioning configurations to be saved using the
function
→
.
The saved configurations can be recalled using the function
→
.
COM - The storage module allows the remote controls to be stored. If the
control panel is replaced, the storage module being used can be inserted
in the new control panel.
WARNING: the storage module must be inserted and removed with
the power supply disconnected, and paying attention to the positioning
direction.
BAT
SBU
BAT - Battery-powered operation.
The batteries are kept charged when the power supply is on. If the power
supply is off, the panel is powered by the batteries until the power is re-
establish or until the battery voltage drops below the safety threshold.
The control panel turns off in the last case. WARNING: the batteries must
always be connected to the control panel for charging. Periodically check
the efficiency of the batteries.
NB: the operating temperature of the rechargeable batteries is from
+5°C to +40°C.
For advanced control of battery-powered operation, refer to the menu
.
Jumper
Description
1
30
1
30
JR5
Selection of power supply - auxil-
iary board.
AUX1 powered from 0-1.
(default)
AUX1 powered from 0-30.
Jumper
Description
OFF
ON
JR1
Display mode selection.
Display mode.
Only the v alue s and pa-
rameters present can be
displayed.
Maintenance mode.
Only the v alue s and pa-
rameters present can be
displayed and modified.
A c t i v a t e d m a i n t e n a n c e
mode is indicated by the
permanent switching on of
the right-hand point on the
display.
14. Jumper setting
