Service and Installation Manual
For warranty service, call 866-417-6140
8
MAINTENANCE
INSTALL DRAFT ARM AND PARTS LIST
Place rubber washer over draft arm mounting holes in cabinet, put beer line connector down through hole.
Next, secure draft arm with four screws.
Insert air hose (one inch plastic tube) in draft arm, being careful not to disturb insulation. Remove top cover
of draft arm and attach air hose clip to the insulating sleeve at the top of the draft arm. Replace top cover.
The air hose clip will assure that the hose remains in proper place at all times, keeping the beer faucet cold.
1. Beer Keg
2. “D” Sharp Keg Tap
3. Beer Line
4. Beer Dispenser
5. CO
2
Line
6. CO
2
Tee Joint
7. CO
2
Regulator
8. CO
2
Cylinder
9. CO
2
Line#1
10. CO
2
Line#2
ONE DOOR CO
2
KNOCK-OUT
This instruction is the procedure for installing a remote CO
2
container for one door unit.
REQUIRED TOOLS
•
Pliers
•
Power Drill
•
Silicone Sealer
•
Drill bit, 1/2”
STEP 1 - Remove black knockout plug with a pair of pliers.
NOTE: Knockout plug for CO
2
line can be locate in two different areas.
View diagram to locate these two areas.
STEP 2 - Use drill and bit to bore hole straight back through wall into compressor compartment.
STEP 3 - Snake CO
2
line through hole down and around exiting behind rear castor underneath rear grill.
STEP 4 - Seal hole around CO
2
line with silicone sealer to prevent cold air leakage.
Don't lay CO
2
cylinders flat.
Don't drop CO
2
cylinders.
