Enterasys AP2650, Руководство по установке, Страница: 39 / 58

Connecting an Ethernet Cable to the Enterasys Wireless Outdoor AP
Enterasys Wireless Outdoor AP Installation Guide 3-9
Connecting an Ethernet Cable to the Enterasys Wireless Outdoor
AP
You can connect the Ethernet cable to the Enterasys Wireless Outdoor AP’s RJ ‐ 45 jack.
To connect an Ethernet cable to the Enterasys Wireless Outdoor AP:
1. Insert the connector of the Ethernet cable in the corresponding socket of the Enterasys
Wireless Outdoor AP. The location of the socket for RX and TX is depicted in Figure 3 ‐ 6 .
Figure 3-6 Position of the Ethernet Port with the Housing Cover Removed
2. Secure the Ethernet cable with a strain relief clamp.
Connecting an External Antenna Cable to the Enterasys Wireless
Outdoor AP
For each WLAN port, there are two R ‐ SMA sockets on the Enterasys Wireless Outdoor AP to
connect external antennas. Figure 3 ‐ 7 shows how the R ‐ SMA sockets are assigned to the WLAN
ports.
To connect an external antenna cable to the Enterasys Wireless Outdoor AP:
1. Insert the connector on the antenna cable into the R ‐ SMA socket and tighten the sleeve nut on
the socket (key size SW8), tightening torque 0.6 Nm.
Note: First connect the cable for antenna "B" if you want to use two antennas for an interface. Once
the cable for antenna "A" is connected, it is difficult to reach socket "B".