Application Note
Installing the Management Interface Card
Installing and Configuring the Management Interface Card
AVN-AN-MGMT-R10
Page 3 of 14
Removing the ANG-3000/7000 series from the Rack
To remove the ANG-3000/7000 series from the rack, you must first gracefully shut it
down to avoid hard disk errors. Follow the instructions below:
1.
On your desktop, click Start, select Programs and double-click Command
Prompt.
2.
Telnet to your ANG. Type: telnet
xxx.xxx.xxx.xxx
(your ANG IP address) and
press
ENTER
.
3.
Login (the default is
netadmin
) and press
ENTER
.
4.
Type your password (the default is
netadmin
) and press
ENTER
.
5.
Login as superuser by typing su - and press
ENTER
.
6.
Type the default password welcome and press
ENTER
.
7.
Save the ANG configuration and shut down all Enterasys services by typing
init 0 and press
ENTER
.
8.
Wait a couple minutes then power off the ANG by holding the power button in
for 4 seconds.
9.
Remove the Ethernet cable connections.
10. Unfasten the two screws holding the ANG flanges to the rack as shown in
Figure 3.
Figure 3
ANG Fastened to Rack
11. Slide the ANG out of the rack as far as possible.
12. When the assembly locks, press the lock arm on both sides of the rails to
release the ANG as shown in Figure 4.
Remove screws
