Quick Start User Guide V2.4
INTRODUCTION
The Entel HT649 is a GMDSS IP68 submersible marine handheld radio that
operates on the VHF marine band and has 19 channels.
To meet your exact requirements the radio may have been customised by
your Entel dealer. These features will be explained in a separate guide
issued by the dealer.
PACKING LIST
PACKAGE 1
HT649
Marine VHF radio
CLB750G
Primary battery
CAT40
High efficiency antenna
LY600
Lanyard
PACKAGE 2 AS PACKAGE 1 PLUS
CNB750E
Rechargeable Li-Ion battery (secondary)
CCAHT
Trickle charger pod
CWCHT
Mains adaptor
CWCHT12
12v charger lead
ASPACKCAHV3
Bulkhead screw and spacer kit
OPTIONAL ACCESSORIES
Attaching and removing accessories
1.
To attach an accessory, remove the accessory
cover by unscrewing the locking screw anti-
clockwise (leave the cover attached or store in
a safe place).
2.
Plug the accessory into the socket, then
carefully tighten the locking screw clockwise
until finger tight (do not overtighten or use any
implement)
3.
To remove an accessory, unscrew the
locking screw of the accessory by hand in
an anti-clockwise direction. Ensure you re-fit
the accessory socket cover (the radio is not
submersible without the socket covered).
BATTERY INFORMATION
Primary (CLB750G - Yellow) battery use
1.
This is a non-rechargeable, single use Lithium battery
2.
The battery is supplied with a security seal that must only be removed
immediately before use
3.
An expiry date is printed on the battery. Regularly check the date of your
batteries and replace as required. Immediately, and safely, dispose of any
out-of-date batteries.
Secondary (CNB750E - Black) battery charging
1.
Connect the AC adaptor or 12V charging lead to the charger pod
and plug in
2.
Turn the radio off and insert the battery pack into the charger pod, either
with or without the radio attached. The charger LED status light changes
to red and charging begins
3.
When charging is complete, the charger status LED changes from red to
green (a fully discharged battery pack will take approximately 6 hours to
recharge)
CAUTION
BATTERY PACK PRECAUTIONS
•
Do not recharge the battery pack if it is already fully charged. Doing so
may reduce the life of the battery pack
•
After charging is complete, remove the battery from the charger
•
Please ensure that the radio is turned off before placing it in the charger
and never switch a radio on whilst in the charger
•
Only use Entel branded battery packs and chargers
•
Do not short the battery terminals or dispose of the battery in a fire
•
Do not charge the radio and/or battery pack if they are wet
DANGER
DO NOT DISASSEMBLE OR MODIFY THE BATTERY IN ANY WAY!
Your Entel battery pack incorporates a safety circuit to avoid danger, if the
safety circuit is damaged or bypassed, or the battery cells are damaged
directly, they may generate extreme heat, smoke, rupture and emit flames.
CONTROLS & INDICATORS
7 KEY LCD
1.
On/Off button. Press and hold to turn the radio on or off
2.
MEM Button:
Adds / removes the currently selected channel to / from
the scan list.
SCAN Button:
Starts/Stops scanning the channels added to the scan
list.
16 Button:
Toggles between the currently selected channel and
channel 16.
MON Button:
Latches squelch open
3.
Channel up / down buttons
4.
Push To Talk (PTT) button. Press to speak and release to listen.
5.
Non-programmable button
6.
Short press toggles LCD and keypad backlight on/off. Long press
toggles keypad lock on/off
7.
Non-programmable button
8
. LED Indicator
Red steady
- Transmitting
Red flashing slowly
- Battery needs recharging
Green steady
- Receiving
Amber pulsing
– In standby mode
9.
Volume Control
10.
Microphone
1
2
8
9
5
4
6
10
Tal
k Here
3
7
