12
ARAMUS STANDARD BAG ASSEMBLIES
User Manual | Rev. B 03/20 | Entegris, Inc.
SHIPPING
Based on currently available information, the RoSS
shells may give user the best chance for successfully
shipping your product in an Aramus bag assembly.
However, since each company’s product likely has
unique freezing characteristics, the combined use
of RoSS shells and Aramus bag assemblies should
be fully validated by the customer.
As always, the customer is responsible for verifying fit
for use in combination with their product and in their
specific application.
INSPECTION
When unpacking the RoSS shell, be sure not to
scratch the stainless-steel shell cover when removing
the plastic overwrap. If a knife is used, keep the blade
point away from the stainless-steel shell cover.
Place the RoSS shell horizontally on a table making
sure the product label is oriented correctly.
ASSEMBLY INSTRUCTIONS
Step 1: Open RoSS Shell
Pull open the four, stainless-steel upper tabs; two
on the sides and two in the middle near the recessed
handle. Slide open the stainless-steel top lid until
completely removed.
Keep the lid fully removed and stored in a horizontal
position until step 5.
Step 2: Remove Foam Layers
Remove only the upper tubing foam and the rod foam
before placing the bag inside.
CAUTION! Safe foam pads along the sides
are attached to the RoSS shell and will be
damaged if they are removed.
Step 3: Fill and Insert Aramus Bag
Fill the Aramus bag to correct fill volume (see Specifi-
cations, page 11). It is suggested to fill to maximum
volume. If the bag is 10 L or greater, fill the bag while
it is inside the RoSS shell.
NOTE: The RoSS system will not work correctly if the
Aramus bag is positioned improperly.
Place the Aramus bag in the middle with the bag
chamber on the stainless-steel base, between the
side foam pads. The rod section needs to be placed
to the very back of the shell.
Wrap the tubing in a loose coil and place on top of
the lower tubing foam. Ensure the clamps on the
tubing are placed in a horizontal orientation to fit in
the shell and that the tubing and bag do not overlap.
Upper tabs
Lower foam,
DO NOT remove
Upper foam
Rod foam
Safe foam
Rod section