Tango 250 user’s manual
2
SAFETY INFORMATION
PROTECTION FROM ELECTRIC SHOCK
Warning!
This product is for professional use only. It is not for household or residential use.
This product presents risks of lethal or severe injury due to fire and heat, electric shock, ultraviolet
radiation, lamp explosion, and falls. Read this manual before powering or installing the fixture, follow the
safety precautions listed below and observe all warnings in this manual and printed on the fixture. If you
have any question about how to use this fixture safely, please contact your Entar dealer.
Warning!
Always disconnect from mains supply before replacing the lamp.
Disconnect the fixture from AC power before removing or installing the lamp, fuse, or any part, and when
not in use.
Always ground (earth) the fixture electrically.
Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
Do not expose the fixture in rain and moisture.
Refer any service operation not described in this manual to a qualified technician.
PROTECTION FROM UV RADIATION AND LMP EXPLOSION
Never operate the fixture with missing or damaged lenses and/or covers.
When replacing the lamp, allow the fixture to cool for at least 15 minutes before opening the fixture of
removing the lamp. Protect your hands and eyes with gloves and safety glasses.
Do not stare directly into the light. Never look at an exposed lamp while it is lit.
Replace the lamp if it becomes defective or worn out, or before usage exceeds the maximum service life.
PROTECTION FROM BURNS AND FIRE
Danger!
Intense heat. Avoid contact by persons and materials.
The exterior of the fixture can get very hot – up to 120
°
C. Allow the fixture to cool for at least 45
minutes before handling.
Prolonged exposure to unshielded lamp can cause eye and skin burns.
Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with ones of
the specified type and rating.
Keep all combustible materials (for example fabric, wood, paper) at least 1 meter away from the fixture.
Keep flammable materials well away from the fixture.
Do not illuminate surfaces within 3 meters (10 feet) of the fixture.
Provide a minimum clearance of 0.1 meters around fans and air vents.
Never place filters or other materials over the lens.
