ensto BETA-BT Series, Инструкция по установке и эксплуатации

Страница: 12 / 21

12
RAK124 / © Ensto 2019
• The “ Calendar ”, “ Boost ” and “ Vacation ” buttons are on / off buttons. When the temperature change is acti -
vated, the “ Calendar ” and “ Vacation ” buttons are green, the “ Boost ” button is orange.
• When the function ” Adaptive temperature change ” is active, the thermostat will advance the heating, so
that the desired temperature has been reached at the scheduled time. By default, the function is on.
External Temperature Change
• You can use external temperature change, if external voltage has been connected to the heater.
• Disable / Enable the function from “ Settings / External control ”.
• From “ Temperature ” you can set desired absolute temperature value. “ Temperature change ” can be either
a rise or a drop in the set point temperature. The default for external control is absolute temperature 10 ° C.
• The blue LED indicator (B) is on when the temperature change is in use.
• If the “ External Control / Temperature ” is enabled you cannot use the adjustment knob for setting tem-
perature.
Home Screen, figure 6.3
F Active device
G Set point temperature
H
Actual temperature
K
On / Off button
L
Enter editing mode
Resetting the Factory Settings, figure 6.4
• Remove the adjustment knob (D).
• Press the Bluetooth button (E) on the heater.
• After 7 seconds, the blue LED (B) indicator B starts to blink quickly.
• Paired devices, consumption information and calendar settings are removed.
Battery
• The purpose of the battery is to maintain the time during power cuts. If the clock does not keep correct
time, the battery must be replaced. The battery change interval is several years and is usage dependent.
The battery may only be replaced by a skilled or instructed person.
Disconnect the power supply before replacing the battery.
• Remove the thermostat, figure 7.
• The battery is located on the thermostat circuit card.
• Replace the battery with same type of battery as the original, CR1632.
• Put the thermostat in place.
• Dispose of the empty battery according to local recycling guidelines.
Environmental Aspects
The heater’s cardboard packing is suitable for recycling.
When the heater is at the end of the life cycle, it must be disposed of properly according to local recy-
cling guidelines.
Warranty
The warranty period for Ensto Beta heaters is 5 years from the date of purchase but no longer than 6 years from
the date of manufacture. The manufacture date is located on the rating label.
Warranty terms, see the product card www.ensto.com.
Declaration of Conformity
Hereby, Ensto Finland Oy declares that the Beta-BT heaters are in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following internet address: www.ensto.com.