Enputech Purelight Series, Руководство пользователя

Страница: 4 / 8

| Purelight UV Light Wand OPERATION |
Set Up for Purelight UV Light Wand:
Assemble the power cord.
Insert power cord connector into the handle of the Purelight UV Light Wand
Plug AC cord into electrical outlet.
Battery Operation Summary:
The Purelight UV Light Wand has four different modes of operation (including “Ready Mode”)
1. Ready / Off Mode [Standby]
2. Safety Mode Operation [5minutes]
3. Basic Mode Operation [2hours]
4. Serial Mode Operation [Serial]
PLEASE NOTE : TO TURN OFF UV LAMP FROM SAFETY, BASIC AND SERIAL MODE OPERATION,
PRESS BUTTON ONCE.
A. Ready/Off Mode [Standby Indicator]:
When plugged in green “charge” light come on to tell you that the
battery is recharging and/or ready to use, also “- -” light comes on to
tell you that you’re in “Ready/Off Mode”. Push switch button once to be
in “Ready/Off Mode”
Please note that from “Ready / Off Mode” Purelight will shut off
automatically.
B. Safety Mode Operation [5 minute Indicator]:
1. Note that when the switch is pushed once, it will make a “beep”
sound, but the UV lamp is still not on.
2. To enter “Safety Mode” [5 minutes], rapidly press the switch twice.
After successfully pressing the switch, there will be a “beep” sound
and [05] light plus the green “Lamp” light at the top left hand corner
of the indicator panel will come on indicating that Purelight is in the
“Safety Mode”
This green “Lamp” light indicates whenever UV lamp is ON.
3. When using the “Safety Mode” [5 minutes]. the UV lamp will
automatically shut off after 5 minutes.
4. While in “Safety Mode” [5 minutes], every 10 seconds there will be a “beep” sound. Since in most
cases, it only takes 10 to 20 seconds of direct exposure of UV-C light to kill most household
germs, the intermittent “beep” sounds can be used as a timing signal to gauge necessary
exposure of an object or area being sanitized.
5. To turn off the UV lamp before 5 minutes, simply push the switch once.
4
Exhibit A : Ready/Off Mode
Exhibit B : Safety Mode