5 of 5
EnPointe Fencin
g
EP-W01 User Manual
If the conditions above are met, further transmitter testin
g
is
not required. However, the OEM inte
g
rator is still
responsible for testin
g
their end-product for any additional
compliance requirements required with this installed module.
The end product with this module may be subject to FCC
part 15 unintentional emissions test requirements.
Important note:
If these conditions cannot be met (for
example, certain laptop confi
g
urations or co-location with
another
transmitter),
then the FCC authorization is no lon
g
er
considered valid and the FCC ID cannot be used on the final
product. In these circumstances, the OEM inte
g
rator is
responsible for re-evaluatin
g
the end product (includin
g
the
transmitter) and obtainin
g
a separate FCC authorization.
END PRODUCT LABELLING
Any device incorporatin
g
this module must include an
external, visible, permanent markin
g
or label which states:
“Contains FCC ID: 2A3F8W01”.
MANUAL INFORMATION TO END USER
The OEM inte
g
rator must be aware not to provide
information to the end user re
g
ardin
g
how to install or
remove this RF module in the user’s manual of the end
product which inte
g
rates this module. The end user manual
shall include all required re
g
ulatory information/warnin
g
as
shown in this manual.
EnPointe Fencin
g
Pty Ltd
5a Hartnett Close
Mul
g
rave
Victoria
Australia
3170
support@enpointefencin
g
.com
enpointefencin
g
.com
v1.2; February 2022
